The woodworking processing center has high processing accuracy and stable processing quality. The automatic tool changing function of the machining center can effectively reduce the clamping times of the workpiece, reduce or eliminate the positioning errors caused by multiple clamping, and improve the processing accuracy. When the position accuracy of each part is required to be high, the automatic tool changing function of the machining center can reduce positioning and tool alignment errors very conveniently and effectively. It can complete the processing of each part in the process of one-time clamping and tool alignment, and ensure the position accuracy requirements of each processing part.

　　激光器中氪燈出廠說明氪燈的使用壽命為300小時，但由于用戶使用條件不同，上述時間并不能作為更換氪燈的依據。隨著使用時間的增加，氪燈的發光效率下降，激光輸出也隨之減弱，很多用戶為了獲得足夠的激光輸出，就加大激光電源的電流，使氪燈發光增強，這使氪燈老化加快，形成惡性循環，有時會導致炸燈現象。為了防止這種現象發生，我們建議用戶按下面的方法決定是否應該更換氪燈。

　　The krypton lamp's service life in laser is 300 hours, but the above time can not be used as the basis for replacing krypton lamp because of different user's use conditions. With the increase of using time, the luminous efficiency of krypton lamp decreases and the output of laser decreases. In order to get enough laser output, many users increase the current of laser power supply to enhance the luminous intensity of krypton lamp, which accelerates the aging of krypton lamp, forms a vicious circle and sometimes leads to the phenomenon of lamp explosion. In order to prevent this phenomenon, we recommend that users decide whether to replace krypton lamp according to the following methods.

　　如果交換后不動軸走動正常，則可說明該軸所對應的驅動塊已損壞，需要更換好驅動塊。如果不動軸還是不行就說明電纜線或電機有故障更換電纜線或者電機。三軸均不能動。此時檢查一下三軸航空插頭是否已和控制箱連接好，控制箱電源是否已打開。數據線是否和控制箱和電腦主機中控制卡連接好。如果以上都正常，則請和廠方聯系。

　　If the fixed axle moves normally after switching, it can be explained that the corresponding driving block of the axle has been damaged, and the driving block needs to be replaced. If the movable shaft is still not available, it means that the cable or motor has a fault to replace the cable or motor. The three axes are immovable. At this time, check whether the three-axis air plug has been connected to the control box and whether the power supply of the control box has been turned on. Whether the data line is well connected with the control box and the control card in the host computer. If all the above are normal, please contact the manufacturer.